S14Clock Firmware Installer

---

Instructions

• Connect clock via usb-c to computer.
• Select formware and hit the blue "Connect" button below, a pop-up window will appear.
• On the clock side, press and hold '0', then press 'RST', release 'RST', and finally release '0'.
• You should see an "ESP32-S2 (COM?)" entry in the pop-up window, if not, release last step.
• Select "ESP32-S2 (COM?)" entry and then hit the greem "Connect" button.
• Select the "Install ....Firmware..." option, confirm by clicking "Install".
• Popup shows progress on Prepare Installation, Erasing, Installing,.., this takes 3 or 4 minutes in total.
• Reset clock after flashing and continue with initial setup.

See the S14Clock Project.

Select your product

• S14Clock All Hardware Versions (Firmware 2.03)
• S14Clock All Hardware Versions (Firmware 2.02)
• S14Clock 24 Characters (Firmware 2.01)
• S14Clock 12 Characters (Firmware 2.01)
• S14Clock All HW, Beta testers only (Firmware beta)